Agilent Technologies MSO6102A Programmer's Reference Manual page 91

Trigger Menu
Holdoff
External probe attenuation
External Units
External Impedance
See Also
•
Example Code
Example program from the start:
page 614
Agilent 6000 Series Oscilloscopes Programmer's Reference
"Introduction to Common (*) Commands"
' RESET - This command puts the oscilloscope into a known state.
' This statement is very important for programs to work as expected.
' Most of the following initialization commands are initialized by
' *RST. It is not necessary to reinitialize them unless the default
' setting is not suitable for your application.
myScope.WriteString "*RST"
Commands by Subsystem
60 ns
AutoProbe (if AutoProbe is connected),
otherwise 1.0:1
Volts
1 M Ohm
on page 77
' Reset the oscilloscope to the defaults.
"VISA COM Example in Visual Basic"
3
on
91