Agilent Technologies MSO6102A Programmer's Reference Manual page 168

3
Commands by Subsystem
Table 50 :CHANnel<n> Commands Summary (continued)
Command
:CHANnel<n>:PROBe:STYPe
<signal type> (see
page 180)
:CHANnel<n>:PROTection
(see page 181)
:CHANnel<n>:RANGe
<range>[suffix] (see
page 182)
:CHANnel<n>:SCALe
<scale>[suffix] (see
page 183)
:CHANnel<n>:UNITs
<units> (see page 184)
:CHANnel<n>:VERNier {{0
| OFF} | {1 | ON}} (see
page 185)
Introduction to
<n> ::= {1 | 2 | 3 | 4} for the four channel oscilloscope models
:CHANnel<n>
<n> ::= {1 | 2} for the two channel oscilloscope models
Commands
The CHANnel<n> subsystem commands control an analog channel (vertical
or Y- axis of the oscilloscope). Channels are independently programmable
for all offset, probe, coupling, bandwidth limit, inversion, vernier, and
range (scale) functions. The channel number (1, 2, 3, or 4) specified in the
command selects the analog channel that is affected by the command.
A label command provides identifying annotations of up to 6 characters.
You can toggle the channel displays on and off with the
:CHANnel<n>:DISPlay command as well as with the root level commands
:VIEW and :BLANk.
The obsolete CHANnel subsystem is supported.
N O T E
Reporting the Setup
168
Query
:CHANnel<n>:PROBe:STYPe
? (see page 180)
:CHANnel<n>:PROTection?
(see page 181)
:CHANnel<n>:RANGe? (see
page 182)
:CHANnel<n>:SCALe? (see
page 183)
:CHANnel<n>:UNITs? (see
page 184)
:CHANnel<n>:VERNier?
(see page 185)
Options and Query Returns
<signal type> ::= {DIFFerential |
SINGle}
<n> ::= 1-2 or 1-4 in NR1 format
{NORM | TRIP}
<n> ::= 1-2 or 1-4 in NR1 format
<range> ::= Vertical full-scale
range value in NR3 format
[suffix] ::= {V | mV}
<n> ::= 1-2 or 1-4 in NR1 format
<scale> ::= Vertical units per
division value in NR3 format
[suffix] ::= {V | mV}
<n> ::= 1-2 or 1-4 in NR1 format
<units> ::= {VOLTs | AMPeres}
<n> ::= 1-2 or 1-4 in NR1 format
{0 | 1}
<n> ::= 1-2 or 1-4 in NR1 format
Agilent 6000 Series Oscilloscopes Programmer's Reference