Agilent Technologies MSO6102A Programmer's Reference Manual page 353

CAN Id specification is set by the :TRIGger:CAN:PATTern:ID
and:TRIGger:CAN:PATTern:ID:MODE commands.
CAN Data specification is set by the :TRIGger:CAN:PATTern:DATA
command.
CAN Data Length Code is set by the :TRIGger:CAN:PATTern:DATA:LENGth
command.
SOF is the only valid selection for analog oscilloscopes. If the automotive CAN and LIN
N O T E
serial decode option (Option AMS) has not been licensed, SOF is the only valid selection.
Query Syntax
:TRIGger:CAN:TRIGger?
The :TRIGger:CAN:TRIGger? query returns the current CAN trigger on
condition.
Return Format
<condition><NL>
<condition> ::= {SOF | DATA | ERR | IDD | IDE | IDR | ALL | OVER | ACK}
Errors •
See Also
•
•
•
•
•
•
•
•
Agilent 6000 Series Oscilloscopes Programmer's Reference
"- 241, Hardware missing"
"Introduction to :TRIGger Commands"
":TRIGger:MODE" on page 338
":TRIGger:CAN:PATTern:DATA"
":TRIGger:CAN:PATTern:DATA:LENGth"
":TRIGger:CAN:PATTern:ID"
":TRIGger:CAN:PATTern:ID:MODE"
":TRIGger:CAN:SIGNal:DEFinition"
":TRIGger:CAN:SOURce"
on page 535
on page 332
on page 345
on page 346
on page 347
on page 348
on page 529
on page 351
Commands by Subsystem
3
353