Agilent Technologies MSO6102A Programmer's Reference Manual page 151

3
Commands by Subsystem
Introduction to
<n> ::= {1 | 2}
:BUS<n>
The BUS subsystem commands control the viewing, labeling, and digital
Commands
channel makeup of two possible buses.
These commands are only valid for the MSO models.
N O T E
Reporting the Setup
Use :BUS<n>? to query setup information for the BUS subsystem.
Return Format
The following is a sample response from the :BUS1? query. In this case,
the query was issued following a *RST command.
:BUS1:DISP 0;LAB "BUS1";MASK +255
Agilent 6000 Series Oscilloscopes Programmer's Reference 151