Agilent Technologies MSO6102A Programmer's Reference Manual page 254

3
Commands by Subsystem
Return Format for <meas_spec> = DELay:
{ <edge_spec1> | <edge_spec2> | <edge_spec1>,<edge_spec2>} <NL>
for <meas_spec> = THResholds and <threshold mode> = PERCent:
THR,PERC,<upper>,<middle>,<lower><NL>
<upper>, <middle>, <lower> ::= A number specifying the upper, middle,
for <meas_spec> = THResholds and <threshold mode> = ABSolute:
THR,ABS,<upper>,<middle>,<lower><NL>
<upper>, <middle>, <lower> ::= A number specifying the upper, middle,
for <threshold spec> = STANdard:
THR,PERC,+90.0,+50.0,+10.0
See Also
•
•
•
•
•
•
•
254
"Introduction to :MEASure Commands"
":MEASure:DELay" on page 255
":MEASure:SOURce"
":CHANnel<n>:RANGe"
":CHANnel<n>:SCALe"
":CHANnel<n>:PROBe"
":CHANnel<n>:UNITs"
and lower threshold percentage values
between Vbase and Vtop in NR3 format.
and lower threshold voltages in NR3
format.
on page 248
on page 270
on page 182
on page 183
on page 177
on page 184
Agilent 6000 Series Oscilloscopes Programmer's Reference