Setting The Resume Function - Omron NT31 Setup Manual

System Settings

6-9-10 Setting the Resume Function

Reference:
The NT31/NT31C has a function to keep the contents of the memory tables even
when the power to the NT31/NT31C is OFF and write back them to the host
when the power is turned ON.
If the resume function is OFF, the memory tables are initialized to these initial
values on switching to the RUN mode. If the resume function is ON, these are not
initialized and are kept the battery-backed up contents.
When the memory table is initialized, its contents are reset to the initial state that
is set by the Support Tool.
When the system is started up the next time, the screen is displayed using the
previous contents of the memory table.
• ON:
The resume function is used.
• OFF:
The resume function is not used.
The default (factory) setting is OFF.
S When the voltage of the NT31/NT31C's built-in battery becomes low, the
memory table contents cannot be retained even if ON is set for the resume
function.
S For details on the resume record function, refer to 2-15-3 Resume Function in
the Reference Manual.
Section 6-9
179