Setting Up The Fibre Channel Cards - Fujitsu ETERNUS DX Configuration Manual

Chapter 4 Operations When Using Brocade Fibre Channel Cards
4.3 Setting Up the Server
5
Add the results in the "WWN instance management table for the server".
Example:
Physical slot
name
PCIE1
PCIE2
6
Check the controller number of the target connected to the Fibre Channel card.
Use the following command to check the controller number of the target connected to the Fibre Chan-
nel card. The controller number corresponds to the physical path displayed in
# cfgadm -v
Example:
Ap_Id
When
c2
unavailable
c3
unavailable
7
Add the results in the "WWN instance management table for the server".
Example:
Physical slot
name
PCIE1
PCIE2
This completes the "WWN instance management table for the server".
4.3.2

Setting Up the Fibre Channel Cards

Brocade Command line Utility (BCU) is bundled with the Brocade Fibre Channel card driver.
Use the "bcu" command to check the port ID and to set the port speed, topology, and frame data size.
Port ID
•
Use the information obtained in
75) to check the port ID.
Port ID check command
bcu port --list
FUJITSU Storage ETERNUS DX, ETERNUS AF Configuration Guide -Server Connection- (Fibre Channel) for Oracle Solaris
WWN
100000051ee7457b
100000051ee7457c
Receptacle Occupant
Type Busy phys_ID
connected configured
fc-fabric n /devices/pci@7c0/pci@0/pci@8/bfa@0/fp@0,0:fc
connected configured
fc-fabric n /devices/pci@7c0/pci@0/pci@8/bfa@0,1/fp@0,0:fc
WWN
100000051ee7457b
100000051ee7457c
"4.3.1 Creating a WWN Instance Management Table for the Server" (page
77
Copyright 2017 FUJITSU LIMITED
Controller num-
Instance name
ber
bfa0
bfa1
Condition Information
unknown
unknown
Controller num-
Instance name
ber
c2 bfa0
c3 bfa1
Physical path name
/pci@7c0/pci@0/pci@8/bfa@0
/pci@7c0/pci@0/pci@8/bfa@0,1
Step (1).
Physical path name
/pci@7c0/pci@0/pci@8/bfa@0
/pci@7c0/pci@0/pci@8/bfa@0,1
P3AM-6312-18ENZ0