Required Driver Parameters; Setting Up The Parameters - Fujitsu ETERNUS DX Configuration Manual

Chapter 3 Setup Procedure for QLogic Fibre Channel Cards
3.5

Required Driver Parameters

3.5 Required Driver Parameters
3.5.1

Setting Up the Parameters

The parameters in the "/kernel/drv/qla2300.conf" configuration file need to be edited as described below.
Original configuration file must be backed up before editing.
Example:
cp /kernel/drv/qla2300.conf ./qla2300.conf.backup
Edit the configuration file according to the following parameter list.
3.5.1.1 qla2300.conf Parameter Values
• These settings are common for all Solaris 10 OS, Solaris 9 OS, and Solaris 8 OS versions.
Proper instance names should be specified in place of the item names.
•
Check the "3.3.1 Creating a WWN Instance Management Table for the Server" (page 56)
•
instance numbers to use in the "hbaX" below.
Parameter
hbaX-SCSI-target-id-<X>-fibre-channel-
port-name="<Storage WWPN>";
hbaX-max-frame-length
hbaX-execution-throttle
hbaX-login-retry-count
hbaX-enable-adapter-hard-loop-ID
hbaX-adapter-hard-loop-ID
hbaX-enable-LIP-reset
hbaX-enable-LIP-full-login
hbaX-enable-target-reset
hbaX-reset-delay
hbaX-port-down-retry-count
hbaX-port-down-retry-delay
hbaX-maximum-luns-per-target
hbaX-connection-options
FUJITSU Storage ETERNUS DX, ETERNUS AF Configuration Guide -Server Connection- (Fibre Channel) for Oracle Solaris
Setting value (for direct Setting value (for switch
connection) connection)
(*1) (*1)
2048 2048
Arbitrary (*2) Arbitrary (*2)
(Up to 512 for each FC (Up to 512 for each FC
port of the ETERNUS port of the ETERNUS
DX/AF) DX/AF)
8 8
1 0
125 0
0 0
0 0
0 0
5 5
8 8
0 0
8 8
0 1
66
Copyright 2017 FUJITSU LIMITED
for the actual "X"
Remarks
—
—
Non-default value
—
1 for direct connection
For each direct connection
instance: assign in de-
scending order, starting at
125
—
Non-default value
—
—
—
—
—
0 for direct connection
•
• 1 for switch connection
P3AM-6312-18ENZ0