For Driver Versions Before V6.30G - Fujitsu ETERNUS DX Configuration Manual

Chapter 2 Setup Procedure for Emulex Fibre Channel Cards
2.5 Required Driver Parameters
2.5.2

For Driver Versions Before V6.30g

Edit the configuration file according to the following parameter list.
2.5.2.1 lpfc.conf Parameter Values
Parameter
log-verbose
log-only
lpfcX-fcp-bind-method
fcp-bind-WWNN
fcp-bind-WWPN
fcp-bind-DID
lpfcX-automap
lun-queue-depth
tgt-queue-depth
lpfcNtM-lun-throttle
lpfcNtM-tgt-throttle
no-device-delay
network-on
FUJITSU Storage ETERNUS DX, ETERNUS AF Configuration Guide -Server Connection- (Fibre Channel) for Oracle Solaris
Setting value
Setting value
(for switch connec-
(for direct connection)
tion)
0x0 0x0
1 1
4 2
Not required Not required
Not required (*1)
Not required Not required
1 0
For the ETERNUS For the ETERNUS
• •
DX60 S2/DX80 S2/ DX60 S2/DX80 S2/
DX90 S2: Not re- DX90 S2: Not re-
quired quired
For the ETERNUS For the ETERNUS
• •
DX400 S2 series and DX400 S2 series and
the ETERNUS DX8000 the ETERNUS DX8000
S2 series: 20 S2 series: 20
For the ETERNUS For the ETERNUS
• •
DX60 S2/DX80 S2/ DX60 S2/DX80 S2/
DX90 S2: Not re- DX90 S2: Not re-
quired quired
For the ETERNUS For the ETERNUS
• •
DX400 S2 series and DX400 S2 series and
the ETERNUS DX8000 the ETERNUS DX8000
S2 series: 512 S2 series: 512
Not required Not required
• For the ETERNUS • For the ETERNUS
DX60 S2/DX80 S2/ DX60 S2/DX80 S2/
DX90 S2: 40 DX90 S2:
40 ¸ (No. of Server-
• For the ETERNUS
DX400 S2 series and side Fibre Channel
the ETERNUS DX8000 ports connected to
S2 series: Not re- each ETERNUS-side
quired CA port) (Round the
result down)
Use the value of "8" if
the actual result is
lower.
• For the ETERNUS
DX400 S2 series and
the ETERNUS DX8000
S2 series: Not re-
quired
0 0
0 0
47
Copyright 2017 FUJITSU LIMITED
lpfcX
Remarks
(Instance name)
— —
— —
Yes An instance name is
specified for each in-
stance.
— —
— —
— —
Yes An instance name is
specified for each in-
stance.
— —
— —
— —
— —
— —
— —
P3AM-6312-18ENZ0