For Switch Connection - Fujitsu ETERNUS DX Configuration Manual

Chapter 1 Operations When Using Oracle Fibre Channel Cards
1.4 Setting Up the Server to Recognize the Logical Units
1.4.2

For Switch Connection

Use the following commands to enable the server to access the logical units.
1
Execute the following commands to check the path of the ETERNUS DX/AF to be connected.
# cfgadm -al
Example:
# cfgadm -al
Ap_Id
c4
c4::21ff00e000a8ffaf disk
c5
c5::25ff00e000a8ffaf disk
2
Use the following command for each path obtained in
Repeat this step for all paths to be used.
# cfgadm -c configure
The underlined portion indicates the path obtained in
Example:
# cfgadm -c configure c4::21ff00e000a8ffaf
# cfgadm -c configure c5::25ff00e000a8ffaf
3
Use the following command to confirm that the paths to the ETERNUS DX/AF are now usable.
"Occupant" status changes from "unconfigured" to "configured".
# cfgadm -al
# cfgadm -al
Ap_Id
c4
c4::21ff00e000a8ffaf disk
c5
c5::25ff00e000a8ffaf disk
The underlined portion indicates that the ETERNUS DX/AF CA (WWN:25ff00e000a8ffaf) is connected to
the Fibre Channel card port with controller number "c5".
FUJITSU Storage ETERNUS DX, ETERNUS AF Configuration Guide -Server Connection- (Fibre Channel) for Oracle Solaris
Type Receptacle
fc-fabric connected
connected
fc-fabric connected
connected
Step
Type Receptacle
fc-fabric connected
connected
fc-fabric connected
connected
19
Copyright 2017 FUJITSU LIMITED
Occupant Condition
unconfigured unknown
unconfigured unknown
unconfigured unknown
unconfigured unknown
Step 1.
1.
Occupant Condition
configured unknown
configured unknown
configured unknown
configured unknown
P3AM-6312-18ENZ0