Fujitsu ETERNUS DX Configuration Manual page 69

Chapter 3 Setup Procedure for QLogic Fibre Channel Cards
3.5 Required Driver Parameters
3.5.1.2 /kernel/drv/qla2300.conf Example
The following example is for an ETERNUS DX8100/DX8400/DX8700 switch connection.
# Copyright (C) QLogic Corporation 1996-2008. All rights reserved.
#
# File is setup as the default parameters for all adapters in the
# system.
# If a parameter needs to be changed for a particular adapter,
# make a copy of the parameter. Then change the hba number
# (decimal) in the parameter to match the adapter instance number
# that is displayed during the boot process. Now alter the
# parameter for the adapter.
#
# example:
# Setting loop down timeout for adapter instance 3 and 4
# respectively.
#
# Before:
# hba0-link-down-timeout=60;
#
# After:
# hba0-link-down-timeout=60;
# hba3-link-down-timeout=120;
# hba4-link-down-timeout=240;
#
#
# ===============================
# Target Persistent Name Binding
# ===============================
#
# Note: This persistent binding section only applies if the string
# "qla-mp-config-required" does NOT exist.
# the fact that the GUI or CLI utilities have made alternate
# persistent binding entries which override the manual persistent
# binding entries documented in this section.
#
# The Persistent Name Binding support for target devices associates a
# SCSI target ID to a specified device World Wide Port Name. In other
# words, this entry changes the target ID of the specified device
# to the number specified in the entry.
#
# To enable it, lines of the following format should be added
# in the qla2300.conf file:
#
# hba<#>-SCSI-target-id-<#>-fibre-channel-port-name="<device WWPN>";
hba0-SCSI-target-id-16-fibre-channel-port-name="2150000b5d6a0109";
hba1-SCSI-target-id-16-fibre-channel-port-name="2151000b5d6a0109";
#
# For example, to associate the following WWPN with target ID 2
# on adapter instance 1, the entry will be:
#
# hba1-SCSI-target-id-2-fibre-channel-port-name="2100002037004ac9";
#
# *******
# IMPORTANT
# *******
#
# - Unlike other parameter entries in the qla2300.conf file, values
# indicated in persistent name binding entries for instance 0 does
# not apply to other instances when there are no entries for the
# other instances.
# - Persistent Name Binding entries are optional entries in the
# qla2300.conf file.
# are scanned by the driver, and do not perform any device masking,
# unless the "Persistent Binding Only Option" is set. Absence of
# this entry for any given device name or SCSI ID does not direct
# the driver to perform any type of device masking, unless the
# "Persistent Binding Only Option" is set.
#
# - For target devices, if no Persistent Name Binding entries are
# specified, the default SCSI target IDs assigned will be the loop
# ID of the devices, if failover is disabled else will start at 0.
# Please refer to the FAQ section for which default SCSI target IDs
# are assigned to fabric devices.
#
# ***********************
# CAUTION CAUTION CAUTION
# ***********************
#
FUJITSU Storage ETERNUS DX, ETERNUS AF Configuration Guide -Server Connection- (Fibre Channel) for Oracle Solaris
This string refects
For both direct connections and switch connections, add these settings.
These entries do not dictate which devices
69
Copyright 2017 FUJITSU LIMITED
P3AM-6312-18ENZ0