Fujitsu ETERNUS DX Configuration Manual page 65

Chapter 3 Setup Procedure for QLogic Fibre Channel Cards
3.4 Setting Up the Server to Recognize the Logical Units
3.4.1.2 Getting the Server to Recognize the Logical Units
The server now needs to use the new sd driver settings to recognize the logical units.
1
Reconfigure and reboot the server to get it to recognize the listed logical units. Execute the following
command.
The ETERNUS DX/AF can be reconfigured by creating the "/reconfigure" file and rebooting the server.
# touch /reconfigure
# /usr/sbin/shutdown -y -g0 -i6
2
After the server has booted up, log in as a superuser, and use the "format" command to confirm that
the storage system and all the logical units have been correctly recognized.
# format
Example:
• Target ID=16, lun=0 and 1 of ETERNUS DX400 S2 series are connected to the physical path "/pci@b,
2000/QLGC,qla@2", and c4t16d0 and c4t16d1 are assigned to each of these LUNs.
Target ID=16, lun=0 and 1 of ETERNUS DX400 S2 series are connected to the physical path "/pci@b,
•
2000/QLGC,qla@2,1", and c5t16d0 and c5t16d1 are assigned to each of these LUNs.
# format
Searching for disks...done
AVAILABLE DISK SELECTIONS:
0. c0t0d0 <SUN18G cyl 7506 alt 2 hd 19 sec 248>
/sbus@3,0/SUNW,fas@3,8800000/sd@0,0
1. c4t16d0 <FUJITSU-ETERNUS_DX400 cyl 260 alt 2 hd 64 sec 256>
/pci@b,2000/QLGC,qla@2/sd@0,0
2. c4t16d1 <FUJITSU-ETERNUS_DX400 cyl 260 alt 2 hd 64 sec 256>
/pci@b,2000/QLGC,qla@2/sd@0,1
3. c5t16d0 <FUJITSU-ETERNUS_DX400 cyl 260 alt 2 hd 64 sec 256>
/pci@b,2000/QLGC,qla@2,1/sd@0,0
4. c5t16d1 <FUJITSU-ETERNUS_DX400 cyl 260 alt 2 hd 64 sec 256>
/pci@b,2000/QLGC,qla@2,1/sd@0,1
3
Check that "sd@xx,x" has been displayed following the physical path name.
This message enables you to check that the logical units are recognized by the sd driver.
FUJITSU Storage ETERNUS DX, ETERNUS AF Configuration Guide -Server Connection- (Fibre Channel) for Oracle Solaris
65
Copyright 2017 FUJITSU LIMITED
P3AM-6312-18ENZ0