Installing The Fibre Channel Card Driver; Setting Up The Server - Fujitsu ETERNUS DX Configuration Manual

Chapter 4 Operations When Using Brocade Fibre Channel Cards
4.2

Installing the Fibre Channel Card Driver

Setting Up the Server to Recognize the Logical Units (LUNs)
Set the server to recognize the ETERNUS DX/AF storage systems' logical units.
"4.4 Setting Up the Server to Recognize the Logical Units" (page 81)
•
After completing all the required procedures in this manual, proceed to "Setting the Multipaths" in
"Configuration Guide -Server Connection- (Fibre Channel) for Oracle Solaris".
4.2 Installing the Fibre Channel Card Driver
Install the Fibre Channel card driver.
Download and install the driver from the Brocade web-site.
Refer to the following Brocade web-site for instructions on how to install the driver.
http://www.brocade.com/
4.3

Setting Up the Server

The server setup will vary according to how the ETERNUS DX/AF storage systems and server are to be connec-
ted.
Only switch connections are supported.
The Fibre Channel card Instance name, target WWN, and target ID information are necessary. Check each
item and enter them in the table. Edit the configuration file according to those information and make set-
tings. Refer to the following sections to set.
"4.3.1 Creating a WWN Instance Management Table for the Server" (page 75)
•
"4.3.2 Setting Up the Fibre Channel Cards" (page 77)
•
• "4.3.3 Setting the Configuration File (/etc/system)" (page 80)
FUJITSU Storage ETERNUS DX, ETERNUS AF Configuration Guide -Server Connection- (Fibre Channel) for Oracle Solaris
74
Copyright 2017 FUJITSU LIMITED
P3AM-6312-18ENZ0