Snmp - ZyXEL Communications MAX218M2W User Manual

This screen contains the following fields:
Table 65 SSH
LABEL
Enable
Port Number
Allow
Connection
from WAN
Allow
Connection
from LAN

12.6 SNMP

Use this screen to allow remote access to the WiMAX Device from a network
connection over SNMP.
Click Maintenance > Remote MGMT > SNMP to open this screen as shown
next.
Figure 85 SNMP Screen
This screen contains the following fields:
Table 66 SNMP
LABEL
Enable
Location
Contact
Read
Community
Write
Community
MAX208M2W Series User's Guide
DESCRIPTION
Select this to enable remote management using this service.
Enter the port number this service can use to access the MAX208M2W
Series. The computer must use the same port number.
Select this to allow connections using this service that originate on the
WAN.
Select this to allow connection using this service that originate on the
LAN.
DESCRIPTION
Select this to enable remote management using this service.
Enter the location of the SNMP server (for example, "Engineering Dept.,
Floor 6, Building A, New York City").
Enter contact information for the administrator managing the SNMP
server (for example, "Bill Smith, IT Dept., (555) 555-5454").
Enter the password for the incoming Get and GetNext requests from the
management station. The default is public and allows all requests.
Enter the password for incoming Set requests from the management
station. The default is public and allows all requests.
Chapter 12 Maintenance
169