Table of Contents
Advertisement
Chapter 7 Network Setting
This screen contains the following fields:
Table 34 RIP
LABEL
General Setup
Enable
Redistribute
Active
Type
Metric
Edit
OK
LAN
Direction
Version
Authentication
Authentication
ID
Authentication
Key
WAN
Direction
Version
Authentication
Authentication
ID
Authentication
Key
7.14 Port Forwarding
Use these settings to forward incoming service requests to the ports on your local
network.
Note: Make sure you did not configure a DMZ host in the Network Setting > NAT >
DMZ screen if you want to make the settings of this screen work.
108
DESCRIPTION
Select this to enable RIP on the MAX208M2W Series.
This indicates whether a route is being redistributed.
This indicates what type of route is being redistributed.
This indicates the metric that is being used for redistribution.
Click this to edit a selected route.
Click this to save any changes to the redistribution table.
Set the LAN network direction to use with RIP.
Set the RIP version to use.
Use this option to enable or disable RIP authentication.
Enter the authentication ID to use for RIP authentication.
Enter the authentication key to use for RIP authentication.
Set the WAN network direction to use with RIP.
Set the RIP version to use.
Use this option to enable or disable RIP authentication.
Enter the authentication ID to use for RIP authentication.
Enter the authentication key to use for RIP authentication.
MAX208M2W Series User's Guide
Advertisement
Table of Contents
