Table of Contents
Advertisement
Chapter 10 The VoIP Account Screens
The following table describes the labels in this screen.
Table 52 VoIP > Account 1 (or Account 2) > Feature
LABEL
Feature Settings
Block
Anonymous
Call
Do Not Disturb
(DND)
Hide User ID
MWI
Hold Method
DTMF
DTMF
SIP INFO
Call Forward Setting
Enable call
Forwarding
Unconditional
CF,
Unconditional
CF Target
148
DESCRIPTION
Select this to have the MAX208M2W Series block all incoming calls
from phone that do not send caller ID.
Select this to have the MAX208M2W Series not forward calls to the
phone line.
Select this to not have your calling number display on the callee's
caller ID.
Select this to enable Message Waiting Indicator (MWI) mode for this
phone line. The MAX208M2W Series sends a beeping tone to the
phone when there is at least one voicemail for the number.
Select the method to use when a call is put on hold.
sendonly/recvonly - Select this to allow the MAX208M2W Series to
send voice packets only but disallow to receive any voice packets. The
peer end should change to a state which allows to receive voice
packets from the MAX208M2W Series only but disallow to send any
voice packets.
inactive - Select this to disallow the MAX208M2W Series send or
receive any voice packets.
Control how the MAX208M2W Series handles the tones that the phone
using this extension makes when you push its buttons. One use of the
tones is to distinguish between numbers when trying to dial a PSTN
phone number.
You should use the same mode as your VoIP service provider. The
choices are:
• Out-of-band(RFC 2833) - Follow the RFC 2833 standard and send
the DTMF tones in RTP packets.
• In Band - Send the DTMF tones in the voice data stream. This
works best when you are using a codec that does not use compression
(like G.711). Codecs that use compression (like G.729) can distort the
tones.
Select this to have the MAX208M2W Series send the DTMF tones in
SIP messages.
Select this check box to enable call forward.
Select this if you want the MAX208M2W Series to forward all incoming
calls to the specified phone number, regardless of other rules in this
Call Forward Setting section. Specify the phone number in the
Unconditional CF Target field.
MAX208M2W Series User's Guide
Advertisement
Table of Contents
