Multi-Function Output Setting - Delta CP2000 Series User Manual

Chapter 12 Description of Parameter SettingsCP2000
Settings Functions
55 Motor #1 output
56 Motor #2 output
57 Motor #3 output
58 Motor #4 output
59 Motor #5 output
60 Motor #6 output
61 Motor #7 output
62 Motor #8 output
66 SO contact A (N.O.)
68 SO contact B (N.C.)
Analog input signal level
67
achieved
Output Command of
69
Preheating

Multi-function Output Setting


Settings
 The setting of this parameter is in hexadecimal.
 This parameter is set via bit setting. If a bit is 1, the corresponding multi-function output acts in the
opposite way.
Example:
If Pr02-13=1 and Pr02-18=0, Relay 1 is ON when the drive runs and is OFF when the drive is
stopped.
If Pr02-13=1 and Pr02-18=1, Relay 1 is OFF when the drive runs and is ON when the drive is
stopped.
When setting multi-motor circulative function, the multi-function
output terminal will automatically set up Pr02-13~Pr02-15 and
Pr02-36~Pr02-40 in accordance with Pr12-01's setting.
Status of drive
Normal
STO
STL1~STL3
Multi-function output terminals operate when analog input signal
level is between high level and low level.
Pr.03-44: Select one of the analog signal channel, AVI1, ACI, and
AVI2, that is going to be compared.
Pr.03-45: The high level of analog input, factory setting is 50.00%
Pr.03-46: The low level of analog input, factory setting is 10.00%.
If analog input > Pr.03-45 upper limit, then multi-function output
terminal operates.
If analog input < Pr.03-46 lower limit, then multi-function output
terminal stops outputting.
Active when the preheating is detected.
0000h~FFFFh (0:N.O.; 1:N.C.)
12.1-02-13
Descriptions
Status of safety output
N.O. (MO=66)
Broken circuit
(Open)
Short circuit
(Close)
Short circuit
(Close)
Factory Setting: 0000
N.C. (MO=68)
Short circuit
(Close)
Broken circuit
(Open)
Broken circuit
(Open)