The Fire Mode Reset Procedure - Delta CP2000 Series User Manual

Chapter 12 Description of Parameter SettingsCP2000
Code
103 CSYE CANopen synchronous error
104 CbFE CANopen hardware disconnect
105 CidE CANopen index setting error
CadE CANopen slave station number
106
setting error
CfrE CANopen index setting exceed
107
limit
InrCOM Internal communication
111
overtime error

The Fire mode reset procedure:

When the terminal MIx=58 has become ON OFF, the drive starts to run "fire mode reset procedure",
and will decide "Manual reset" or "Auto reset" fire mode according to the P06-86 bit1 selection.
Wiring diagram:
1. When the AC power ON, RB1/ RC1 contacts=ON, and RA1/ RC1=OFF.
2. When operating at the fire mode with no bypass indication function, RB1/ RC1=ON, and the motor is
driven by the drive.
Error name
Normal
Fire Mode
mode
V Not-detectable
V Not-detectable
V Not-detectable
V Not-detectable
V Not-detectable
V Not-detectable
12.1-06-29
Enable bypass
function
Not-detectable
Not-detectable
Not-detectable
Not-detectable
Not-detectable
Not-detectable