Software Version; Parameter Protection Password Input; Parameter Protection Password Setting - Delta CP2000 Series User Manual

Software Version

Settings Read only

Parameter Protection Password Input


Settings 0~65535
Display
 This parameter allows user to enter their password (which is set in Pr.00-08) to unlock the
parameter protection and to make changes to the parameter.
 Pr.00-07 and Pr.00-08 are used to prevent the personal miss-operation.
 When the user have forgotten the password, clear the setting by input 9999 and press ENTER
key, then input 9999 again and press Enter within 10 seconds. After decoding, all the settings will
return to factory setting.
 All parameters will be read as 0 when the password is setting, except Pr. 00-08.

Parameter Protection Password Setting


Settings 0~65535
 To set a password to protect your parameter settings. In the first time, password can be set
directly. After setting, the value of 00-08 will become 1, which means password protection is
activated. When the password is set, if any parameter setting needs to be changed, be sure to
enter correct password in 00-07, and then the password will be inactivated temporarily with
00-08 changing to 0. At this time, parameters setting can be changed. After setting, re-power the
motor drive, and password will be activated again.
 To cancel the password protection, after entering correct password in 00-07, 00-08 also needs to
be set as 0 again to inactive password protection permanently. If not, password protection will be
active after motor drive re-power.
 The keypad copy function will work normally only when the password protection is inactivated
temporarily or permanently, and password set in 00-08 will not be copied to keypad. So when
copying parameters from keypad to motor drive, the password need to be set manually again in
the motor drive to active password protection.
Password Decode Flow Chart
Pass word Setting
00-08
Displays 01 after
correct password is
entered to Pr.00-08.
0~4 (the times of password attempts)
0: No password protection / password is entered correctly (Pr00-07)
1: Password has been set
Pass word Forgotten
00-07
Enter 9999 and press ENTER,
then ente r 9999 aga in withi n 10
se cond s an d pre ss ENTER.
Then all pa ra meters will re set
to factory se ttings .
12.1-00-5
Chapter 12 Description of Parameter SettingsCP2000
Pass word Incorrect
00-07
3 chan ces of p assword inpu t:
Inc orre ct p assword 1: d ispl ays "01"
Inc orre ct p assword 2: disp lays "02 "
Inc orre ct p assword 3: "Pcode "(blin king)
Keyp ad will be locked after 3 wrong attemp ted
passwords. To re-activate t he keypa d, pl ease
reboo t the drive an d in put t he correct
password.
Factory Setting:
Read only
Factory Setting: 0
Factory Setting: 0