Alcatel-Lucent 7710 SR OS Configuration Manual page 414

src-ip
Syntax
Context
Description
Default
Parameters
src-port
Syntax
Context
Description
Default
Parameters
Page 414
src-ip [ipv6-address/prefix-length]
no src-ip
config>filter>ipv6-filter>entry>match
This command configures a source IPv6 address range to be used as an IP filter match criterion.
The no form of the command removes the source IPv6 address match criterion.
no src-ip
ipv6-address — The IP prefix for the IP match criterion in dotted decimal notation.
Values x:x:x:x:x:x:x:x (eight 16-bit pieces)
x:x:x:x:x:x:d.d.d.d
x [0..FFFF]H
d [0 — 255]D
prefix-length — The IPv6 mask value for the IPv6 filter entry.
Values 1 — 128
ip-prefix-list — creates a list of IPv4 prefixes for match criteria in IPv4 ACL and CPM filter
policies.
ip-prefix-list-name — A string of up to 32 characters of printable ASCII characters. If special
characters are used, the string must be enclosed within double quotes.
src-port {lt | gt | eq} src-port-number
src-port range start end
no src-port
config>filter>ip-filter>entry>match
config>filter>ipv6-filter>entry>match
This command configures a source TCP or UDP port number or port range for an IP filter match
criterion. Note that an entry containing L4 match criteria will not match non-initial (2nd, 3rd, etc)
fragments of a fragmented packet since only the first fragment contains the L4 information.
The no form of the command removes the source port match criterion.
no src-port
lt | gt | eq — Specifies the operator to use relative to src-port-number for specifying the port number
match criteria.
lt specifies all port numbers less than src-port-number match.
gt specifies all port numbers greater than src-port-number match.
eq specifies that src-port-number must be an exact match.
7710 SR OS Router Configuration Guide