Alcatel-Lucent 7710 SR OS Configuration Manual page 110

Parameters
triggered-policy
Syntax
Context
Description
static-route
Syntax
Context
Description
Page 110
dscp-name — Specifies the DSCP name.
Values
be, ef, cp1, cp2, cp3, cp4, cp5, cp6, cp7, cp9, cs1, cs2, cs3, cs4, cs5, nc1, nc2, af11,
af12, af13, af21, af22, af23, af31, af32, af33, af41, af42, af43, cp11, cp13, cp15,
cp17, cp19, cp21, cp23, cp25, cp27, cp29, cp31, cp33, cp35, cp37, cp39, cp41,
cp42, cp43, cp44, cp45, cp47, cp49, cp50, cp51, cp52, cp53, cp54, cp55, cp57,
cp58, cp59, cp60, cp61, cp62, cp63
fc-name — Specifies the forward class name.
Values be, l2, af, l1, h2, ef, h1, nc
triggered-policy
no triggered-policy
config>router
This command triggers route policy re-evaluation.
By default, when a change is made to a policy in the config router policy options context and then
committed, the change is effective immediately. There may be circumstances when the changes
should or must be delayed; for example, if a policy change is implemented that would affect every
BGP peer on a router, the consequences could be dramatic. It would be more effective to control
changes on a peer-by-peer basis.
If the triggered-policy command is enabled, and a given peer is established, and you want the peer to
remain up, in order for a change to a route policy to take effect, a clear command with the soft or soft
inbound option must be used; for example, clear router bgp neighbor x.x.x.x soft. This keeps the
peer up, and the change made to a route policy is applied only to that peer or group of peers.
[no] static-route {ip-prefix/prefix-length | ip-prefix netmask} [preference preference]
[metric metric] [tag tag] [enable | disable] next-hop ip-int-name | ip-address [mcast-family]
[bfd-enable |{cpe-check cpe-ip-address [interval seconds] [drop-count count] [log]}
{prefix-list prefix-list-name [all | none]} |{fc fc-name [priority {low | high}]} ] [ldp-sync]
[no] static-route {ip-prefix/prefix-length | ip-prefix netmask} [preference preference]
[metric metric] [tag tag] [enable | disable] indirect ip-address [ldp | rsvp-te [disallow-igp]]
[cpe-check cpe-ip-address [interval seconds] [drop-count count] [log]] {prefix-list prefix-
list-name [all | none]} |{fc fc-name [priority {low | high}]}
[no] static-route {ip-prefix/prefix-length | ip-prefix netmask} [preference preference]
[metric metric] [tag tag] [enable | disable] black-hole [mcast-family] {prefix-list prefix-list-
name [all | none]}
config>router
This command creates static route entries for both the network and access routes.
7710 SR OS Router Configuration Guide