Alcatel-Lucent 7710 SR OS Configuration Manual page 121

The no form of the command removes BFD from the router interface regardless of the IGP/RSVP.
Default no bfd
Parameters
transmit-interval — Sets the transmit interval, in milliseconds, for the BFD session.
receive receive-interval — Sets the receive interval, in milliseconds, for the BFD session.
multiplier multiplier — Set the multiplier for the BFD session.
echo-receive echo-interval — Sets the minimum echo receive interval, in milliseconds, for the
cflowd
Syntax cflowd {acl | interface} [direction]
no cflowd
Context config>router>interface
Description This command enables cflowd to collect traffic flow samples through a router for analysis.
cflowd is used for network planning and traffic engineering, capacity planning, security, application
and user profiling, performance monitoring, usage-based billing, and SLA measurement. When
cflowd is enabled at the interface level, all packets forwarded by the interface are subjected to
analysis according to the cflowd configuration.
If cflowd is enabled without either egress-only or both specified or with the ingress-only keyword
specified, then only ingress sampling will be enabled on the associated IP interface.
Default
no cflowd
Parameters acl — Specifies the policy associated with a filter.
interface — Specifies the policy associated with an IP interface.
direction — Specifies the direction to collect traffic flow samples.
7710 SR OS Router Configuration Guide
Values
10 — 100000
The minimum value is 300 msec for central BFD sessions
Default
100
Values
10 — 100000
Default
100
Values 3— 20
Default
3
session.
Values
100 — 100000
Default 100
Values
ingress-only — Enables ingress sampling only on the associated interface.
egress-only — Enables egress sampling only on the associated interface.
both — Enables both ingress and egress cflowd sampling.
IP Router Configuration
Page 121