Alcatel-Lucent 7710 SR OS Configuration Manual page 150

Default
Parameters
other-stateful-configuration
Syntax
Description
Default
prefix
Syntax
Context
Description
Default
Parameters
autonomous
Syntax
Context
Page 150
no mtu — The MTU option is not sent in the router advertisement messages.
the MTU for the nodes to use to send packets on the link.
mtu-bytes — Specify
Values
1280 — 9212
[no] other-stateful-configuration
This command sets the "Other configuration" flag. This flag indicates that DHCPv6lite is available
for autoconfiguration of other (non-address) information such as DNS-related information or
information on other servers in the network.See RFC 3736, Stateless Dynamic Host Configuration
Protocol (DHCP) for IPv6
no other-stateful-configuration
[no] prefix [ipv6-prefix/prefix-length]
config>router>router-advert>if
This command configures an IPv6 prefix in the router advertisement messages. To support multiple
IPv6 prefixes, use multiple prefix statements. No prefix is advertised until explicitly configured using
prefix statements.
none
ip-prefix — The IP prefix for prefix list entry in dotted decimal notation.
Values
ipv4-prefix
ipv4-prefix-length
ipv6-prefix
ipv6-prefix-length
prefix-length — Specifies a route must match the most significant bits and have a prefix length.
Values 1 — 128
[no] autonomous
config>router>router-advert>if>prefix
a.b.c.d (host bits must be 0)
0 — 32
x:x:x:x:x:x:x:x (eight 16-bit pieces)
x:x:x:x:x:x:d.d.d.d
x: [0 — FFFF]H
d: [0 — 255]D
0 — 128
7710 SR OS Router Configuration Guide