Alcatel-Lucent 7710 SR OS Configuration Manual page 409

netmask — Any mask epressed in dotted quad notation.
dst-ip
Syntax dst-ip [ipv6-address/prefix-length]
no dst-ip
Context config>filter>ipv6-filter>entry>match
Description This command matches a destination IPv6 address.
To match on the destination IPv6 address, specify the address and prefix length, for example, 11::12/
128.
The no form of the command removes the destination IP address match criterion.
Default
none
Parameters
ipv6-prefix — The IPv6 prefix for the IP match criterion in dotted decimal notation.
prefix-length — The IPv6 prefix length for the ipv6-address expressed as a decimal integer.
ip-prefix-list — creates a list of IPv4 prefixes for match criteria in IPv4 ACL and CPM filter
ip-prefix-list-name — A string of up to 32 characters of printable ASCII characters. If special
dst-port
Syntax dst-port {lt | gt | eq} dst-port-number
dst-port range start end
no dst-port
Context config>filter>ip-filter>entry>match
config>filter>ipv6-filter>entry>match
Description
This command configures a destination TCP or UDP port number or port range for an IP filter match
criterion. Note that an entry containing L4 match criteria will not match non-initial (2nd, 3rd, etc)
fragments of a fragmented packet since only the first fragment contains the L4 information.
The no form of the command removes the destination port match criterion.
Default none
7710 SR OS Router Configuration Guide
Values
0.0.0.0 — 255.255.255.255
Values
ipv6-address
Values
1 — 128
policies.
characters are used, the string must be enclosed within double quotes.
x:x:x:x:x:x:x:x (eight 16-bit pieces)
x:x:x:x:x:x::d.d.d.d
x: [0..FFFF]H
d: [0..255]D
Filter Policies
Page 409