Alcatel-Lucent 7710 SR OS Configuration Manual page 410

Parameters
fragment
Syntax
Context
Description
Default
Parameters
icmp-code
Syntax
Context
Description
Page 410
lt | gt | eq — Specifies the operator to use relative to dst-port-number for specifying the port number
match criteria.
lt specifies all port numbers less than dst-port-number match.
gt specifies all port numbers greater than dst-port-number match.
eq specifies that dst-port-number must be an exact match.
eq — Specifies the operator to use relative to dst-port-number for specifying the port number match
criteria. The eq keyword specifies that dst-port-number must be an exact match.
dst-port-number — The destination port number to be used as a match criteria expressed as a decimal
integer.
Values
0 — 65535
range start end — Specifies an inclusive range of port numbers to be used as a match criteria. The
destination port numbers start-port and end-port are expressed as decimal integers.
Values 0 — 65535
fragment {true | false}
no fragment
config>filter>ip-filter>entry>match
Configures fragmented or non-fragmented IP packets as an IP filter match criterion. Note that an
entry containing L4 match criteria will not match non-initial (2nd, 3rd, etc) fragments of a
fragmented packet since only the first fragment contains the L4 information.
The no form of the command removes the match criterion.
no fragment
true — Configures a match on all fragmented IP packets. A match will occur for all packets that have
either the MF (more fragment) bit set OR have the Fragment Offset field of the IP header set to a
non-zero value.
false — Configures a match on all non-fragmented IP packets. Non-fragmented IP packets are
packets that have the MF bit set to zero and have the Fragment Offset field also set to zero.
icmp-code icmp-code
no icmp-code
config>filter>ip-filter>entry>match
config>filter>ipv6-filter>entry>match
Configures matching on ICMP/ICMPv6 code field in the ICMP/ICMPv6 header of an IPor IPv6
7710 SR OS Router Configuration Guide