Table of Contents
Advertisement
Field
half-duplex mode
full-duplex mode
unknown-duplex mode
Link speed type is autonegotiation
Link speed type is force link
link duplex type is autonegotiation
link duplex type is force link
Maximum frame length
Allow jumbo frames to pass
Broadcast max-
Multicast MAX-
Unicast max-
PVID
MDI type
Port link-type
Tagged VLANs
UnTagged VLANs
Port priority
Last link flapping
Last clearing of counters: Never
Peak input rate
Peak output rate
Last 300 second input
Description
The interface is operating in half duplex mode.
The interface is operating in full duplex mode.
The duplex mode of the interface is unknown because the duplex
mode negotiation fails or the interface is physically disconnected.
The interface is configured with the speed auto command.
The interface is configured with a speed by using the speed
command.
The interface is configured with the duplex auto command.
The interface is configured with a duplex mode by using the
duplex command.
Maximum Ethernet frame length allowed on the interface.
The interface allows jumbo frames to pass through.
Broadcast storm suppression threshold in ratio, pps, or kbps. The
unit of the threshold depends on your configuration.
Multicast storm suppression threshold in ratio, pps, or kbps. The
unit of the threshold depends on your configuration.
Unicast storm suppression threshold in ratio, pps, or kbps. The
unit of the threshold depends on your configuration.
Port VLAN ID (PVID) of the Ethernet interface.
Cable type (depending on your configuration):
•
automdix.
•
mdi.
•
mdix.
Link type of the interface (depending on your configuration):
•
access.
•
trunk.
•
hybrid.
VLANs for which the interface sends packets without removing
VLAN tags.
VLANs for which the interface sends packets after removing
VLAN tags.
Priority of the interface.
Duration since the most recent physical state change of the
interface. Never indicates that the interface state has never
changed.
Time when the reset counters interface command was last
used to clear statistics on the interface. Never indicates that the
reset counters interface command was never used since the
device was started.
Peak rate of inbound traffic in Bps, and the time when the peak
inbound traffic rate occurred.
Peak rate of outbound traffic in Bps, and the time when the peak
outbound traffic rate occurred.
Average rate of inbound traffic in the last 300 seconds, in pps and
Bps, and the ratio of the actual rate to the maximum interface
10
Advertisement
Table of Contents
