Table of Contents
Advertisement
Examples
# Configure VLAN 100 as the PVID of the trunk port GigabitEthernet 1/0/1, and assign
GigabitEthernet 1/0/1 to VLAN 100.
<Sysname> system-view
[Sysname] interface gigabitethernet 1/0/1
[Sysname-GigabitEthernet1/0/1] port link-type trunk
[Sysname-GigabitEthernet1/0/1] port trunk pvid vlan 100
[Sysname-GigabitEthernet1/0/1] port trunk permit vlan 100
Related commands
•
port link-type
•
port trunk permit vlan
MAC-based VLAN commands
display mac-vlan
Use display mac-vlan to display MAC-to-VLAN entries.
Syntax
display mac-vlan { all | dynamic | mac-address mac-address [ mask mac-mask ] | static | vlan
vlan-id }
Views
Any view
Predefined user roles
network-admin
network-operator
Parameters
all: Specifies all MAC-to-VLAN entries.
dynamic: Specifies dynamically configured MAC-to-VLAN entries.
mac-address mac-address: Specifies the MAC address in the MAC-to-VLAN entry.
mask mac-mask: Specifies the mask for matching MAC addresses in MAC-to-VLAN entries.
static: Specifies statically configured MAC-to-VLAN entries.
vlan vlan-id: Specifies the VLAN in MAC-to-VLAN entries. The value range for the vlan-id argument
is 1 to 4094.
Examples
# Display all MAC-to-VLAN entries.
<Sysname> display mac-vlan all
The following MAC VLAN entries exist:
State: S - Static, D - Dynamic
MAC address
0008-0001-0000
0002-0001-0000
Mask
FFFF-FF00-0000
FFFF-FFFF-FFFF
183
VLAN ID
Dot1q
5
3
5
3
State
S
S&D
Advertisement
Table of Contents
