Table of Contents
Advertisement
range of 1 to 4094. If no management VLAN ID is specified, the value 0 is advertised, which means
that the LLDP agent is not configured with a management VLAN ID.
dot3-tlv: Advertises IEEE 802.3 organizationally specific LLDP TLVs.
link-aggregation: Advertises link aggregation TLVs.
mac-physic: Advertises MAC/PHY configuration/status TLVs.
max-frame-size: Advertises maximum frame size TLVs.
power: Advertises power in MDI TLVs and power stateful control TLVs.
med-tlv: Advertises LLDP-MED TLVs.
capability: Advertises LLDP-MED capabilities TLVs.
inventory: Advertises the following TLVs: hardware revision, firmware revision, software revision,
serial number, manufacturer name, model name, and asset ID.
location-id: Advertises location identification TLVs.
civic-address: Inserts the typical address information about the network device in location
identification TLVs .
device-type: Sets a device type value in the range of 0 to 2:
•
Value 0 specifies a DHCP server.
•
Value 1 specifies a switch.
•
Value 2 specifies an LLDP-MED endpoint.
country-code: Sets a country code defined in ISO 3166.
{ ca-type ca-value }&<1-10>: Configures address information. ca-type represents the address
information type in the range of 0 to 255. ca-value represents address information, a string of 1 to
250 characters. &<1-10> indicates that you can specify up to 10 ca-type ca-value pairs.
elin-address: Inserts telephone numbers for emergencies in location identification TLVs.
tel-number: Sets the telephone number for emergencies, a string of 10 to 25 characters.
network-policy [ vlan-id ]: Advertises network policy TLVs. The vlan-id argument specifies the voice
VLAN ID sent to voice terminals, in the range of 1 to 4094. If you do not specify this argument, the
command advertises information about the VLAN assigned by the authentication server or the voice
VLAN ID configured on the interface. For more information, see "Configuring VLANs."
power-over-ethernet: Advertises extended power-via-MDI TLVs.
Usage guidelines
Nearest bridge agents are not supported on aggregate interfaces.
You can enable the device to advertise multiple types of TLVs by using this command without the all
keyword specified.
If the MAC/PHY configuration/status TLV is not advertisable, none of the LLDP-MED TLVs will be
advertised whether they are advertisable. If the LLDP-MED capabilities TLV is not advertisable, the
other LLDP-MED TLVs will not be advertised regardless of whether they are advertisable.
The port and protocol VLAN ID TLV, VLAN name TLV, and management VLAN ID TLV in IEEE 802.1
organizationally specific LLDP TLVs can be configured only for nearest bridge agents. The
configuration can be inherited by nearest customer bridge agents and nearest non-TPMR bridge
agents.
Examples
# Enable the nearest customer bridge agents on GigabitEthernet 1/0/1 to advertise link aggregation
TLVs of the IEEE 802.1 organizationally specific TLVs on GigabitEthernet 1/0/1.
<Sysname> system-view
[Sysname] interface gigabitethernet 1/0/1
284
Advertisement
Table of Contents
