Table of Contents
Advertisement
Field
Maximum transmission unit
Physical: InLoopBack
Last 300 seconds input rate:
bytes/sec, 0 bits/sec, 0 packets/sec
Last 300 seconds output rate:
bytes/sec, 0 bits/sec, 0 packets/sec
Input: 0 packets, 0 bytes, 0 drops
Output: 0 packets, 0 bytes, 0 drops
# Display brief information about interface Inloopback 0.
<Sysname> display interface inloopback 0 brief
Brief information on interfaces in route mode:
Link: ADM - administratively down; Stby - standby
Protocol: (s) - spoofing
Interface
InLoop0
# Display brief information about interface Inloopback 0, including the complete description of the
inloopback interface.
<Sysname> display interface inloopback 0 brief description
Brief information on interfaces in route mode:
Link: ADM - administratively down; Stby - standby
Protocol: (s) - spoofing
Interface
InLoop0
Table 10 Command output
Field
Brief information on interfaces in
route mode
Link: ADM - administratively down;
Stby - standby
Protocol: (s) - spoofing
Interface
Description
MTU of the interface, which is always 1536 and cannot be configured
The physical type of the interface is inloopback.
Average input rate during the last 300 seconds:
•
bytes/sec—Average number of bytes received per second.
0
•
bits/sec—Average number of bits received per second.
•
packets/sec—Average number of packets received per
second.
Average output rate over the last 300 seconds:
•
bytes/sec—Average number of bytes sent per second.
0
•
bits/sec—Average number of bits sent per second.
•
packets/sec—Average number of packets sent per second.
Total number and size (in bytes) of incoming packets of the interface
and the number of dropped packets.
Total number and size (in bytes) of outgoing packets of the interface
and the number of dropped packets.
Link Protocol Primary IP
UP
UP(s)
--
Link Protocol Primary IP
UP
UP(s)
--
Description
Brief information about the inloopback interface.
Explains the Link field values:
•
ADM—The interface has been shut down by the network
administrator. To recover its physical layer state, run the undo
shutdown command.
•
Stby—The interface is a standby interface.
Explains the Protocol field value.
(s)—Represents spoofing. If the data link layer protocol of an interface
is up, but the link is an on-demand link or is not present, the Protocol
field displays UP(s). This attribute is typical of interface Null 0,
Inloopback 0, and loopback interfaces.
Interface name.
43
Description
Description
Advertisement
Table of Contents
