Table of Contents
Advertisement
Default
A service loopback group does not contain any ports.
Views
Layer 2 Ethernet interface view
Predefined user roles
network-admin
Parameters
number: Specifies a service loopback group ID. The value range for the number argument is 1 to
1024.
Usage guidelines
Before assigning a port to a service loopback group, make sure the port supports the service type of
the group.
You can assign a maximum of 8 ports to a service loopback group.
When you assign a port to a service loopback group, the system removes the configuration on the
port. For correct traffic processing, make sure a service loopback group has a minimum of one
member port when it is being used by a feature.
Examples
# Assign GigabitEthernet 1/0/1 to service loopback group 5.
<Sysname> system-view
[Sysname] interface gigabitethernet 1/0/1
[Sysname-GigabitEthernet1/0/1] port service-loopback group 5
service-loopback group
Use service-loopback group to create a service loopback group and specify its service type.
Use undo service-loopback group to delete the service loopback group.
Syntax
service-loopback group number type { { multicast-tunnel | tunnel } *| multiport }
undo service-loopback group number
Views
System view
Predefined user roles
network-admin
Parameters
number: Specifies a service loopback group ID in the range of 1 to 1024.
type: Specifies the service type of the service loopback group.
multicast-tunnel: Specifies the multicast tunnel service.
tunnel: Specifies the unicast tunnel service.
multiport: Specifies the multiport ARP service.
Usage guidelines
The device supports only one service loopback group.
287
Advertisement
Table of Contents
