Table of Contents
Advertisement
Deleting a Layer 2 aggregate interface also deletes the Layer 2 aggregation group. At the same time,
the member ports of the aggregation group, if any, leave the aggregation group.
Examples
# Create Layer 2 aggregate interface Bridge-Aggregation 1, and enter its view.
<Sysname> system-view
[Sysname] interface bridge-aggregation 1
[Sysname-Bridge-Aggregation1]
lacp edge-port
Use lacp edge-port to configure an aggregate interface as an edge aggregate interface.
Use undo lacp edge-port to restore the default.
Syntax
lacp edge-port
undo lacp edge-port
Default
An aggregate interface does not operate as an edge aggregate interface.
Views
Layer 2 aggregate interface view
Predefined user roles
network-admin
Usage guidelines
Use this command on the aggregate interface that connects the device to a server if dynamic link
aggregation is configured only on the device. This feature enables all member ports of the
aggregation group to forward packets to improve link reliability.
This command takes effect only on an aggregate interface corresponding to a dynamic aggregation
group.
Link-aggregation traffic redirection cannot operate correctly on an edge aggregate interface.
Examples
# Configure Layer 2 aggregate interface Bridge-Aggregation 1 as an edge aggregate interface.
<Sysname> System-view
[Sysname] interface bridge-aggregation 1
[Sysname-Bridge-Aggregation1] lacp edge-port
lacp mode
Use lacp mode passive to configure LACP to operate in passive mode on a port.
Use undo lacp mode to restore the default.
Syntax
lacp mode passive
undo lacp mode
Default
LACP operates in active mode on a port.
92
Advertisement
Table of Contents
