Table of Contents
Advertisement
To verify the configuration of the first interface in the interface range, execute the display this
command in interface range view.
To view the member interfaces of an interface range, use the display interface range command.
When you bulk configure interfaces, follow these guidelines:
•
You cannot enter the view of some interfaces by using the interface interface-type
interface-number command. Do not configure any of these interfaces as the first interface in the
interface range.
•
Do not assign both an aggregate interface and any of its member interfaces to an interface
range. Some commands, after being executed on both an aggregate interface and its member
interfaces, can break up the aggregation.
•
No limit is set on the maximum number of interfaces in an interface range. The more interfaces
in an interface range, the longer the command execution time.
•
The maximum number of interface range names is limited only by the system resources. As a
best practice, configure fewer than 1000 interface range names to guarantee bulk interface
configuration performance.
Examples
# Add GigabitEthernet 1/0/1 through GigabitEthernet 1/0/12 to interface range named myEthPort,
and enter the interface range view.
<Sysname> system-view
[Sysname] interface range name myEthPort interface gigabitethernet 1/0/1 to
gigabitethernet 1/0/12
[Sysname-if-range-myEthPort]
# Enter the view of interface range named myEthPort.
<Sysname> system-view
[Sysname] interface range name myEthPort
[Sysname-if-range-myEthPort]
Related commands
display interface range
55
Advertisement
Table of Contents
