Routing Policy Configuration Example For Ipv6 Route Redistribution - HP FlexFabric 12900E Series Configuration Manual

6. Apply the routing policy to route redistribution:
# On Switch B, enable route redistribution from IS-IS to OSPF and apply the routing policy.
[SwitchB] ospf
[SwitchB-ospf-1] import-route isis 1 route-policy isis2ospf
[SwitchB-ospf-1] quit
# Display the OSPF routing table on Switch A.
[SwitchA] display ospf routing
Routing for Network
Destination
192.168.1.0/24
Routing for ASEs
Destination
172.17.1.0/24
172.17.2.0/24
172.17.3.0/24
Total Nets: 4
Intra Area: 1
The output shows that the cost of route 172.17.1.0/24 is 100 and the tag of route 172.17.2.0/24
is 20.
Routing policy configuration example for IPv6 route
redistribution
Network requirements
As shown in
•
Run RIPng on Switch A and Switch B.
•
Configure three static routes on Switch A.
•
On Switch A, apply a routing policy to redistribute static routes 20::/32 and 40::/32 and deny
route 30::/32.
Figure 113 Network diagram
20::/32
30::/32
40::/32
Vlan-int200
11::1/32
Switch A
Configuration procedure
1. Configure Switch A:
# Configure IPv6 addresses for VLAN-interface 100 and VLAN-interface 200.
OSPF Process 1 with Router ID 192.168.1.1
Routing Tables
Cost
1
Cost
100
1
1
Inter Area: 0
Figure 113:
Vlan-int100
Vlan-int100
10::1/32
10::2/32
Type NextHop
Transit 192.168.1.1
Type Tag
Type2 1
Type2 20
Type2 1
ASE: 3 NSSA: 0
Switch B
485
AdvRouter Area
192.168.1.1 0.0.0.0
NextHop AdvRouter
192.168.1.2 192.168.2.2
192.168.1.2 192.168.2.2
192.168.1.2 192.168.2.2