Configuring The Continue Clause - HP FlexFabric 12900E Series Configuration Manual

Step
16. Set a preferred value for BGP
routes.
17. Set a prefix priority.
18. Set a local QoS ID for
matching routes.
19. Set a tag value for IGP routes.
20. Set a traffic index for BGP
routes.
21. Set a backup link for fast
reroute (FRR).

Configuring the continue clause

Follow these guidelines when you configure the continue clause to combine multiple nodes:
•
If you configure an apply clause that sets different attribute values on all the nodes, the apply
clause of the node configured most recently takes effect.
•
If you configure the following apply clauses on all the nodes, the apply clause of each node
takes effect:
apply as-path without the replace keyword.

apply cost with the + or – keyword.

apply community with the additive keyword.

apply extcommunity with the additive keyword.

•
The apply comm-list delete clause configured on the current node cannot delete the
community attributes set by the apply community clauses of the preceding nodes.
To configure the continue clause:
Step
1. Enter system view.
2. Enter routing policy node
view.
Command
apply preferred-value
preferred-value
apply prefix-priority { critical
| high | medium }
apply qos-local-id
{ local-id-value | clear }
apply tag tag-value
apply traffic-index { value |
clear }
•
Set an IPv4 backup link
for
apply fast-reroute
{ backup-interface
interface-type
interface-number
[ backup-nexthop
ip-address ]
backup-nexthop
ip-address }
•
Set an IPv6 backup link
for
apply ipv6 fast-reroute
backup-nexthop
ipv6-address
Command
system-view
route-policy route-policy-name
{ deny | permit
node-number
481
Remarks
By default, no preferred value is set
for BGP routes.
By default, no prefix priority is set,
which means the prefix priority is
low.
By default, no local QoS ID is set.
By default, no tag value is set for
IGP routes.
By default, no traffic index is set for
BGP routes.
FRR:
By default, no backup link is set for
|
FRR.
FRR:
Remarks
N/A
} node
N/A