HP FlexFabric 12900E Series Configuration Manual page 491

Step
3. Match routes
destination, next hop, or source
address matches an ACL or
prefix list.
4. Match BGP routes
AS_PATH attribute matches a
specified AS path list.
5. Match BGP routes
COMMUNITY
matches a
community list.
6. Match routes having
specified cost.
7. Match BGP routes
extended community attribute
matches a specified extended
community list.
8. Match routes having
specified output interface.
9. Match BGP routes having the
specified local preference.
10. Match routes having MPLS
labels.
11. Match routes having
specified route type.
12. Match IGP routes having the
specified tag value.
Command
•
Match
destination, next hop, or source
address matches an ACL or
IPv4
if-match
next-hop | route-source } { acl
ipv4-acl-number | prefix-list
whose
prefix-list-name }
•
Match
destination, next hop, or source
address matches an ACL or
IPv6
if-match ipv6 { address |
next-hop | route-source } { acl
ipv6-acl-number | prefix-list
prefix-list-name }
whose
if-match
as-path-number&<1-32>
if-match
whose
{ { basic-community-list-number |
attribute
name
specified
whole-match
[
adv-community-list-number }&<1-32
>
the
if-match cost cost-value
whose
if-match
ext-comm-list-number&<1-32>
the
if-match interface { interface-type
interface-number }&<1-16>
if-match
preference
if-match mpls-label
if-match
{ external-type1
external-type1or2 | external-type2
the
| internal
is-is-level-2 | nssa-external-type1 |
nssa-external-type1or2
nssa-external-type2 } *
if-match tag tag-value
479
IPv4 routes whose
prefix list:
ip { address |
IPv6 routes whose
prefix list:
as-path
community
comm-list-name }
] |
extcommunity
local-preference
route-type
|
| is-is-level-1 |
|
Remarks
By default, no ACL or prefix
list match criterion
configured.
If the ACL used by an
if-match clause does not
exist, the clause is always
matched. If no rules of the
specified ACL are matched
or the match rules are
inactive, the clause is not
matched.
The ACL specified in an
if-match clause must be a
non-VPN ACL.
All IPv6 routes match a node
if the if-match clauses of the
node use only IPv4 ACLs.
All IPv4 routes match a node
if the if-match clauses of the
node use only IPv6 ACLs.
By default, no AS path match
criterion is configured.
By default, no COMMUNITY
match criterion is matched.
By default, no cost match
criterion is configured.
By default, no extended
community list match
criterion is configured.
By default, no output
interface match criterion is
configured.
This command is
supported by BGP.
By default, no
preference is configured for
BGP routes.
By default, no MPLS label
match criterion is configured.
By default, no route type
match criterion is configured.
By default, no tag match
criterion is configured.
is
not
local