Configuring Is-Is Network Management - HP FlexFabric 12900E Series Configuration Manual

Step
2. Enter interface view.
3. Enable
suppression on the
interface.

Configuring IS-IS network management

This task includes the following configurations:
•
Bind an IS-IS process to MIB so that you can use network management software to manage the
specified IS-IS process.
•
Enable IS-IS notifications to report important events.
To report critical IS-IS events to an NMS, enable SNMP notifications for IS-IS. For SNMP
notifications to be sent correctly, you must also configure SNMP on the device. For more information
about SNMP configuration, see the network management and monitoring configuration guide for the
device.
To configure IS-IS network management:
Step
1. Enter system view.
2. Bind MIB to an IS-IS
process.
3. Enable
notification sending.
4. Enter IS-IS view.
5. Configure
context name for the
SNMP
managing IS-IS.
Command
interface interface-type interface-number
prefix
isis prefix-suppression
Command
system-view
isis mib-binding process-id
snmp-agent
[ adjacency-state-change
area-mismatch
authentication-type
buffsize-mismatch
id-length-mismatch
lsdboverload-state-change
IS-IS
lsp-corrupt
lsp-size-exceeded
manual-address-drop
max-seq-exceeded
maxarea-mismatch | own-lsp-purge |
protocol-support | rejected-adjacency |
skip-sequence-number | version-skew ]
*
isis [ process-id
vpn-instance-name ]
the
snmp context-name context-name
object for
trap enable isis
| authentication
lsp-parse-error
|
] [ vpn-instance
156
Remarks
N/A
By default,
suppression is disabled on
the interface.
This command
applicable to the secondary
IP address of the interface.
Remarks
N/A
By default, MIB is bound to the
IS-IS process with the smallest
process ID.
|
|
|
|
|
|
By default, IS-IS
|
sending is enabled.
|
|
|
N/A
By default, no context name is set
for the SNMP object for managing
IS-IS.
prefix
is also
notification