Packet Type-Based Ipv6 Interface Pbr Configuration Example - HP FlexFabric 12900E Series Configuration Manual

Packet type-based IPv6 interface PBR configuration example

Network requirements
As shown in
Switch A to forward all TCP packets received on VLAN-interface 11 to the next hop 1::2. Switch A
forwards other IPv6 packets according to the routing table.
Figure 111 Network diagram
Switch B
Vlan-int10
1::2/64
Vlan-int10
1::1/64
Switch A
Host A
10::3/64
Gateway: 10::2/64
Configuration procedure
1. Configure Switch A:
# Create VLAN 10 and VLAN 20.
<SwitchA> system-view
[SwitchA] vlan 10
[SwitchA-vlan10] quit
[SwitchA] vlan 20
[SwitchA-vlan20] quit
# Configure RIPng.
[SwitchA] ripng 1
[SwitchA-ripng-1] quit
[SwitchA] interface vlan-interface 10
[SwitchA-Vlan-interface10] ipv6 address 1::1 64
[SwitchA-Vlan-interface10] ripng 1 enable
[SwitchA-Vlan-interface10] quit
[SwitchA] interface vlan-interface 20
[SwitchA-Vlan-interface20] ipv6 address 2::1 64
[SwitchA-Vlan-interface20] ripng 1 enable
[SwitchA-Vlan-interface20] quit
# Configure ACL 3001 to match TCP packets.
Figure 111, Switch B and Switch C cannot reach each other. Configure IPv6 PBR on
Switch C
Vlan-int20
2::2/64
Vlan-int20
2::1/64
Vlan-int11
10::2/64
Subnet
10::1/64
Host B
472