Ipv6 Static Route Configuration Example - HP 1910 User Manual

IPv6 static route configuration example

Network requirements
The IP addresses of devices are shown in
and Switch C for any two hosts to communicate with each other.
Figure 274 Network diagram
Host A
1::2/64
Configuration considerations
On Switch A, configure a default route with Switch B as the next hop.
1.
On Switch B, configure one static route with Switch A as the next hop and the other with Switch C
2.
as the next hop.
On Switch C, configure a default route with Switch B as the next hop.
3.
Configuration procedure
Configure a default route to Switch B on Switch A:
1.
Select Network > IPv6 Routing from the navigation tree of Switch A.
a.
Click the Create tab.
b.
Enter :: for Destination IP Address, select 0 from the Prefix Length list, and enter 4::2 for Next
c.
Hop.
Click Apply.
d.
Vlan-int200
4::2/64
Vlan-int200
4::1/64
Vlan-int100
1::1/64
Switch A
Figure 274. Configure IPv6 static routes on Switch A, Switch B
Host B
2::2/64
Vlan-int400
2::1/64
Vlan-int300
5::2/64
Switch B
Vlan-int300
5::1/64
Vlan-int500
3::1/64
Switch C
265
Host C
3::2/64