HP FlexFabric 12900E Series Configuration Manual page 129

Authentication Sequence: [ 0 ]
Neighbor state change count: 6
BFD status: Disabled
Router ID: 3.3.3.3
State: Full
DR: 192.168.1.4
Options is 0x02 (-|-|-|-|-|-|E|-)
Dead timer due in 31
Neighbor is up for 00:01:28
Authentication Sequence: [ 0 ]
Neighbor state change count: 6
BFD status: Disabled
Router ID: 4.4.4.4
State: Full
DR: 192.168.1.4
Options is 0x02 (-|-|-|-|-|-|E|-)
Dead timer due in 31
Neighbor is up for 00:01:28
Authentication Sequence: [ 0 ]
Neighbor state change count: 6
BFD status: Disabled
The output shows that Switch D is the DR and Switch C is the BDR.
3. Configure router priorities on interfaces:
# Configure Switch A.
[SwitchA] interface vlan-interface 1
[SwitchA-Vlan-interface1] ospf dr-priority 100
[SwitchA-Vlan-interface1] quit
# Configure Switch B.
[SwitchB] interface vlan-interface 1
[SwitchB-Vlan-interface1] ospf dr-priority 0
[SwitchB-Vlan-interface1] quit
# Configure Switch C.
[SwitchC] interface vlan-interface 1
[SwitchC-Vlan-interface1] ospf dr-priority 2
[SwitchC-Vlan-interface1] quit
# Display neighbor information on Switch D.
<SwitchD> display ospf peer verbose
OSPF Process 1 with Router ID 4.4.4.4
Area 0.0.0.0 interface 192.168.1.4(Vlan-interface1)'s neighbors
Router ID: 1.1.1.1
State: Full
DR: 192.168.1.4
Options is 0x02 (-|-|-|-|-|-|E|-)
Address: 192.168.1.3
Mode: Nbr is master
BDR: 192.168.1.3
sec
Address: 192.168.1.4
Mode: Nbr is master
BDR: 192.168.1.3
sec
Neighbors
Address: 192.168.1.1
Mode:Nbr is slave
BDR: 192.168.1.3
117
Priority: 1
MTU: 0
Priority: 1
MTU: 0
GR State: Normal
Priority: 100
MTU: 0
GR State: Normal
GR State: Normal