Bgp Ls Configuration Example - HP FlexFabric 12900E Series Configuration Manual

Network
* i 9.1.1.0/24

BGP LS configuration example

Network requirements
As shown in
Switch B and Switch C, and between Switch B and Switch D.
Configure Switch B as a route reflector with client Switch A to allow Switch A to learn LS information
advertised by Switch C and Switch D.
Figure 78 Network diagram
Switch A
Vlan-int11
192.1.1.1/24
Configuration procedure
1. Configure IP addresses for interfaces and configure OSPF on Switch C and Switch D. (Details
not shown.)
2. Configure BGP connections:
# Configure Switch A.
<SwitchA> system-view
[SwitchA] bgp 100
[SwitchA-bgp-default] peer 192.1.1.2 as-number 100
[SwitchA-bgp-default] address-family link-state
[SwitchA-bgp-default-ls] peer 192.1.1.2 enable
[SwitchA-bgp-default-ls] quit
[SwitchA-bgp-default] quit
# Configure Switch B.
<SwitchB> system-view
[SwitchB] bgp 100
[SwitchB-bgp-default] peer 192.1.1.1 as-number 100
[SwitchB-bgp-default] peer 193.1.1.1 as-number 100
[SwitchB-bgp-default] peer 194.1.1.1 as-number 100
[SwitchB-bgp-default] address-family link-state
[SwitchB-bgp-default-ls] peer 192.1.1.1 enable
[SwitchB-bgp-default-ls] peer 193.1.1.1 enable
[SwitchB-bgp-default-ls] peer 194.1.1.1 enable
[SwitchB-bgp-default-ls] quit
[SwitchB-bgp-default] quit
# Configure Switch C.
NextHop
10.1.2.2
Figure 78, all switches run BGP. Run IBGP between Switch A and Switch B, between
Switch B
Vlan-int11
192.1.1.2/24
MED LocPrf
0 100
Switch C
Switch D
339
PrefVal Path/Ogn
0 ?