HP FlexFabric 12900E Series Configuration Manual page 453

Figure 103 Network diagram
2001:1::/64
Table 25 Interface and IP address assignment
Device
Switch A
Switch A
Switch B
Switch B
Switch C
Switch C
Configuration procedure
1. Configure IPv6 addresses for the interfaces. (Details not shown.)
2. Configure basic OSPFv3:
# On Switch A, enable OSPFv3 and specify the router ID as 1.1.1.1.
<SwitchA> system-view
[SwitchA] ospfv3
[SwitchA-ospfv3-1] router-id 1.1.1.1
[SwitchA-ospfv3-1] quit
[SwitchA] interface vlan-interface 10
[SwitchA-Vlan-interface10] ospfv3 1 area 0
[SwitchA-Vlan-interface10] quit
[SwitchA] interface vlan-interface 11
[SwitchA-Vlan-interface11] ospfv3 1 area 0
[SwitchA-Vlan-interface11] quit
# On Switch B, enable OSPFv3 and specify the router ID as 2.2.2.2.
<SwitchB> system-view
[SwitchB] ospfv3
[SwitchB-ospfv3-1] router-id 2.2.2.2
[SwitchB-ospfv3-1] quit
[SwitchB] interface vlan-interface 10
[SwitchB-Vlan-interface10] ospfv3 1 area 0
[SwitchB-Vlan-interface10] quit
[SwitchB] interface vlan-interface 13
[SwitchB-Vlan-interface13] ospfv3 1 area 0
Switch A
Vlan-int10
Vlan-int11
L2 Switch
Area 0
Vlan-int11
Switch C
BFD
Switch B
Vlan-int10
Vlan-int13
Vlan-int13
Interface
Vlan-int10
Vlan-int11
Vlan-int10
Vlan-int13
Vlan-int11
Vlan-int13
441
2001:4::/64
IPv6 address
2001::1/64
2001:2::1/64
2001::2/64
2001:3::2/64
2001:2::2/64
2001:3::1/64