Logging Neighbor State Changes; Configuring Ospf Network Management - HP 5500 EI series Configuration Manual

To enable compatibility with RFC 1583:
Step
1. Enter system view.
2. Enter OSPF view.
3. Enable compatibility
with RFC 1583.

Logging neighbor state changes

Perform this task to enable output of neighbor state change logs to the information center. The
information center processes the logs according to user-defined output rules (whether to output logs and
where to output). For more information about the information center, see Network Management and
Monitoring Configuration Guide.
To enable the logging of neighbor state changes:
Step
1. Enter system view.
2. Enter OSPF view.
3. Enable the logging of
neighbor state changes.

Configuring OSPF network management

This task involves the following configurations:
• Bind an OSPF process to MIB so that you can use network management software to manage the
specified OSPF process.
Enable SNMP notifications for OSPF to report important events.
•
Configure the maximum number of output SNMP notifications within a specified time interval.
•
SNMP notifications are sent to the SNMP module, which outputs the notifications according to the
configured output rules. For more information about SNMP notifications, see Network Management and
Monitoring Configuration Guide.
To configure OSPF network management:
Step
1. Enter system view.
2. Bind OSPF MIB to an
OSPF process.
Command
system-view
ospf [ process-id | router-id router-id |
vpn-instance vpn-instance-name ] *
rfc1583 compatible
Command
system-view
ospf [ process-id | router-id router-id |
vpn-instance vpn-instance-name ] *
log-peer-change
Command
system-view
ospf mib-binding process-id
85
Remarks
N/A
N/A
By default, this feature is enabled.
Remarks
N/A
N/A
By default, this feature is
enabled.
Remarks
N/A
By default, OSPF MIB is bound to
the process with the smallest
process ID.