Choke Set Replacement; Cylinder Stud Bolt Replacement - Honda GX240RT2 Service And Repair Manual

FUEL SYSTEM

CHOKE SET REPLACEMENT

Remove the carburetor
Pull out the choke valve plate (1).
Remove the choke shaft (2) and install a new choke
shaft.
Insert a new choke valve plate into the slit (3) of the
choke shaft.
Be sure the choke shaft is in the position between the
projections (4) of the choke valve plate.
CYLINDER STUD BOLT
REPLACEMENT
Thread two nuts onto the stud bolt and tighten them
together, and then use a wrench to turn the stud bolt
out.
Install new stud bolts.
SPECIFIED LENGTH
STUD BOLT (8 x 98)
STUD BOLT (8 x 106)
STUD BOLT (8 x 115)
STUD BOLT (8 x 123)
STUD BOLT (8 x 131.5) 115.5 mm (4.55 in)
gx240ut2_gx270ut2_gx340ut2_gx390ut2
(page 6-8).
82.0 mm (3.23 in)
90.0 mm (3.54 in)
99.0 mm (3.90 in)
107.0 mm (4.21 in)
(2)
(4)
(1)
STUD BOLT (8 x 98): 82.0 mm (3.90 in)
STUD BOLT (8 x 106): 90.0 mm (3.90 in)
STUD BOLT (8 x 115): 99.0 mm (4.55 in)
STUD BOLT (8 x 123): 107.0 mm (3.90 in)
STUD BOLT (8 x 131.5): 115.5 mm (4.55 in)
(3)
(1)
(2)
(4)