Honda GX240RT2 Service And Repair Manual page 79

gx240ut2_gx270ut2_gx340ut2_gx390ut2
FUEL SYSTEM
FUEL FILLER CAP REMOVAL/
ENGINE SERVICE BULLETIN #40 =>
INSTALLATION
Turn the fuel level gauge (1) to align the fuel filler cap
(5)
tether hole (2) with the cutout (3) of the fuel filler neck, and
(4)
then remove the fuel filler cap (4).
Before installing, check the air vent hole of the fuel filler
cap for clogs. If necessary, clean it using low-pressure
compressed air.
Set the fuel tank cap to the fuel filler neck by aligning the
(1)
projections (5) of the cap with the cutouts of the fuel filler
neck and fuel level gauge, and then turn the fuel tank cap
clockwise 180 degrees to lock it.
(2)
(3)
FUEL FILTER REMOVAL/
INSTALLATION
Remove or install the fuel filter by aligning the cutout (1) of
the fuel filter with the fuel filler cap tether (2) as shown.
Before installing, check the screen of the fuel strainer for
clogs or damage.
(1)
(2)