Honda GX240RT2 Service And Repair Manual page 273

STARTING SYSTEM
FRONT BRACKET/REAR BRACKET
ASSEMBLY
Install the rear bracket (1) to the armature/yoke (2) by
aligning the brush terminal grommet (3) with the cutout
(4) of the rear bracket.
Attach the pinion drive lever (5) to the starter solenoid
(6). Set the pinion drive lever to the overrunning clutch
(7).
Hold the pinion drive lever, starter solenoid, and yoke
together, and install the front bracket (8).
Tighten the through bolts to secure the front bracket
and rear bracket
INSPECTION
PERFORMANCE TEST
Measure starter performance while cranking the engine.
STARTER MOTOR PERFORMANCE:
UNDER LOAD:
CRANKING VOLTAGE:
CRANKING CURRENT:
ENGINE CRANKING SPEED: 1,900 min
NO LOAD:
CRANKING VOLTAGE:
CRANKING CURRENT:
• To get accurate results, the test must be conducted
in the normal ambient temperature.
• Battery: 32A19 (12 V 24AH/5HR)
• Battery cable: 8 sq. x 1.5 m (4.9 ft.) total length of
battery positive cable and battery negative cable.
If the measurement is out of specification, disassemble
and inspect the starter motor.
STARTER SOLENOID
Remove the starter solenoid (1)
Connect a 12 V battery between the starter terminal
and the switch body and check for continuity between
the terminals.
Continuity should exist when the battery is connected
and not exist when the battery is disconnected.
gx240ut2_gx270ut2_gx340ut2_gx390ut2
(page 10-9).
9.0 V
150 A
(rpm) min.
-1
11.5 V
50 A max.
(page 10-9).
(8)
(7)
(5)
(6)
(2)
(4)
(1)
(3)
(1)