Honda GX240RT2 Service And Repair Manual page 178

gx240ut2_gx270ut2_gx340ut2_gx390ut2
CRANKSHAFT BEARING (6207)
Drive out the radial ball bearing (1).
Apply oil to the circumference of a new bearing (2).
Drive the radial ball bearing until it is fully seated on the
end using the special tools.
TOOLS:
Attachment, 72 x 75 mm (3)
Pilot 35 mm (4)
Driver (5)
CRANKSHAFT OIL SEAL
(35 x 52 x 8 mm)
Remove the oil seal from the crankcase cover.
Apply grease to the lip of a new oil seal (1).
Drive the oil seal in the position as shown using the
special tools.
TOOLS:
Attachment 52 x 55 mm (2)
Driver (3)
07746-0010600
07746-0040800
07749-0010000
CIRCUMFERENCE
07746-0010400
07749-0010000
2 mm (0.08 in)
OIL SEAL LIP
(5)
(3)
(4)
(3)
(2)
CRANKCASE
(1)
(2)
(1)