Recoil Starter Assembly - Honda GX240RT2 Service And Repair Manual

RECOIL STARTER ASSEMBLY

To prevent serious eye injury, always wear
safety goggles or other eye protection when us-
ing compressed air.
Pass the recoil starter rope (1) through the hole (2) of the recoil starter
pulley (3), and then tie the rope as shown.
Before installing the recoil starter rope, check for fray or wear.
Wind the recoil starter rope onto the recoil starter pulley counterclockwise.
Hook the outer hook (1) of the starter return spring (2) to the groove (3) of
the recoil starter pulley (4), and then install the starter return spring by
winding it in the starter pulley.
Apply grease to the cutout (1) of the recoil starter case (2).
Set the recoil starter pulley (3) to the recoil starter case by aligning the inner
hook (4) of the starter return spring with the cutout of the recoil starter case.
gx240ut2_gx270ut2_gx340ut2_gx390ut2
STARTING SYSTEM
10 mm
(0.4 in)
(2)
(2)
(2)
(1)
(3)
(1)
(3)
(1)
(4)
(4)
(3)