Honda GX240RT2 Service And Repair Manual page 109

CHARGING SYSTEM
INSTALLATION
Clean the tapered parts (1) of dirt, oil, grease, and other
foreign material before installation. Be sure there are no
metal parts or other foreign material on the magnet part
(2) of the flywheel.
Set the 25 x 18 mm special woodruff key (3) in the key
groove (4) of the crankshaft securely.
Install the flywheel (5) by aligning the key slot (6) with
special woodruff key on the crankshaft.
The flywheel may push the 25 x 18 mm special
woodruff key out of its slot; check after installation.
Attach the cooling fan (1) to the flywheel (2) by aligning
the three projections of the cooling fan with the holes of
the flywheel.
Attach the starter pulley (3) by aligning the hole of the
pulley with the projection at the center of the cooling
fan.
Apply a light coat of oil to the threads and the seating
surface of the 16 mm special nut (1), and loosely
tighten the nut.
Hold the flywheel (2) with a commercially available
strap wrench S-17 (3), and tighten the 16 mm special
nut to the specified torque.
TORQUE: 170 N·m (17.3 kgf·m, 125 lbf·ft)
Install the following parts:
– Ignition coil
– Fan cover
gx240ut2_gx270ut2_gx340ut2_gx390ut2
(page 9-3).
(page 5-2).
(4)
(1)
Align
(2)
(2)
(3)
(3)
(6)
(2)
(5)
(3)
Align
(1)
(1)