Honda GX240RT2 Service And Repair Manual page 247

FUEL SYSTEM
CARBURETOR DISASSEMBLY/
ASSEMBLY
(*) Refer to page of base shop manual (GX240/GX270/GX340/GX390UT2, P/N 61Z5F00E3)
Gasoline is highly flammable and explosive.
You can be burned or seriously injured when han-
dling fuel.
• Keep heat, sparks, and flame away.
• Handle fuel only outdoors.
• Wipe up spills immediately.
To prevent serious eye injury, always wear safety
goggles or other eye protection when using com-
pressed air.
Remove the control gear box
Before disassembly, clean the outside of the carburetor.
PILOT JET SET
ASSEMBLY:
Before installing, clean
thoroughly with low-
pressure compressed air.
Lightly lubricate the O-ring
to ensure easy installation
into the carburetor body.
PILOT SCREW
REPLACEMENT: (page 6-15*)
PILOT SCREW OPENING: (page 2-2)
MAIN NOZZLE
ASSEMBLY: UPPER
Before installing,
SIDE
clean thoroughly with
low- pressure
compressed air.
MAIN JET
ASSEMBLY: UPPER
Before installing, clean SIDE
thoroughly with low-
pressure compressed air.
FLOAT CHAMBER
ASSEMBLY:
Install the float chamber to the
carburetor body at an angle as
shown.
20°
gx240ut2_gx270ut2_gx340ut2_gx390ut2
(page
JET SET SCREW (5 mm)
0.3 N·m (0.03 kgf·m, 0.22 lbf·ft)
O-RING
O-RING
LIMITER CAP
FLOAT
O-RING
SET BOLT GASKET
SET BOLT
6-5).
PAN SCREW (3 6 mm) (2)
SPRING
LEVER SETTING
PLATE
CUP FILTER
REMOVAL/INSTALLATION:
(page 3-8)
*
FLOAT VALVE
FLOAT VALVE
SPRING
FLOAT PIN
SEDIMENT CUP
DRAIN BOLT GASKET
DRAIN BOLT
VALVE LEVER
SPRING
FUEL VALVE
LEVER
FUEL VALVE
PACKING
O-RING