Honda GX240RT2 Service And Repair Manual page 245

FUEL SYSTEM
CONTROL GEAR BOX ASSEMBLY
Apply grease to the O-rings.
Install the O-ring to the groove of the carburetor Assy.
securely.
Install the O-ring and choke lever to the motor case set.
Install the plate to the choke lever arm and install the
Align the cutouts of
choke lever arm/plate to the choke lever.
choke lever arm and
When installing the motor case set, hold the choke
choke lever.
valve fully open as shown.
Install the washers and motor case set screws A/B.
Tighten the motor case set screws A/B to the specified
torque.
TORQUE:2.1 N·m (0.21 kgf·m, 1.5 lbf·ft)
MOTOR CASE SET SCREW B (4 mm) (2)
2.1 N·m (0.21 kgf·m, 1.5 lbf·ft)
O-RING
Replace if necessary.
CHOKE LEVER
gx240ut2_gx270ut2_gx340ut2_gx390ut2
CHOKE LEVER ARM
WASHER (4 mm) (2)
PLATE
CUTOUT
MOTOR CASE SET SCREW A (4 x 17 mm) (2)
2.1 N·m (0.21 kgf·m, 1.5 lbf·ft)
O-RING
Replace if necessary.
CHOKE VALVE
MOTOR CASE SET
CARBURETOR ASSY.